Canada Oilfield Equipment

Flushby Unit 4900

Description

FLUSHBY UNIT 4900

  • 2015 Western Star W4900TS / tandem steer tridem drive.
  • Engine: Detroit DD16 15.6L, 560 HP.
  • 88 hours
  • 2512 km.
  • Eaton Fuller 18 speed transmission.
  • 54’ free-standing mast, 65’ 11” crown to ground. 65,000 lbs static hook load vertical and 50,000 lbs static hook load slant work.
  • Gardner Denver, TEEF 4X5, Triplex Pump c/w Coors #10 steel valves, 6” suction manifold.
  • High pressure piping threaded c/w Oteco relief valve (Neutron Valves)
  • 450HP 1:1 ratio two shaft split box c/w air shift
  • 4:1 ratio chain case assembly c/w splined input shaft
  • Drive-lines fabricated & balanced to accommodate split box and chain case
  • Esso Gear 75W90-GX Extra oil for split box, chain case & triplex
  • Bowie three inch (3”) nitrile geared pump & hydraulic drive package, grease manifold, drip tray mounted on passenger side.
  • Bowie controls at rear control panel
  • Chelsea eight bolt Power-take-off c/w air shift
  • Hydraulic wet kit c/w pumps, filter, piping, hoses, fittings and oil
  • Power tong/BOP circuits
  • Two (2) SJ100 hydraulic rear leveling jacks c/w controls & jack stands
  • Split nuts for SJ100
  • Operators control panel c/w standard controls/gauges
  • HL-25-7-86-3-559 Pullmaster hydraulic winch c/w two speed rapid reverse and 3/4” groove drum (large drum) 3/4” cable for HL25 winch – 350 feet
  • Pullmaster PL5 auxiliary winch
  • 3/8” cable, chain and hook for auxiliary winch
  • Fifty-three (53ft) Flushby mast rated at 65,000# hook load vertical and 50,000# slant
  • Slant tray in mast (Square)
  • Two (2) hydraulic mast raising cylinders
  • Slant arm package c/w controls
  • Two sheave crown assembly for 3/4” wire rope
  • Custom fabricated A-Leg assembly
  • Engineer’s Certification and Inspection (Alberta-Saskatchewan)
  • 65,000 # single sheave traveling block (Heavy Duty)
  • Custom fabricated headache rack assembly
  • Over cab cable protector
  • Cable anchor bar for slip program
  • Rear bumper boxed c/w tow hook
  • One (1) cabinet tool box c/w doors at each end, light and heater mounted behind cab across frame
  • Two (2) aluminum tool boxes, mounted RH and LH rear (drawers in LH box)
  • One (1) varsol tank large with dry compartment –near Bowie as room permits
  • Pail holders as room allows
  • Standard light package c/w back-up alarm
  • Rod BOP c/w hand pump and 25Ft. fire-guard BOP hose (BOP mount)
  • Working floor adjustable for multiple working heights and ladder
  • Fall arrestor safety device c/w certified mounting block.
  • One (1) 25 ton Trico rod hook
  • Two (2) 25 ton Trico rod elevators c/w (4) -1” and plates and screws
  • One (1) 25 ton 1 ¼” plate type elevator c/w (2) 1 ¼” plates and screws
  • Ø Two (2) ¾” x 7/8” rod wrenches
  • Two (2) 1” rod wrenches
  • Trico rod spinner
  • Ground reel and cable
  • Fire extinguisher (2) 30 # ABC Type
  • Emergency warning system
  • Hydraulic weight indicator
  • Advance Aluminum Tank – 1.5m3 hydraulic/ 9m3 product Code TC406 Crude
  • Mounting plate and rest for hydraulic picker
  • 3” suction hose
  • 1 1/2” 5000# pressure hose
  • Electronic Titan tank level gauge (installed)
  • Electronic pressure gauge
  • Electronic counter totalizer

Flushby Unit 4900

Description

FLUSHBY UNIT 4900

  • 2015 Western Star W4900TS / tandem steer tridem drive.
  • Engine: Detroit DD16 15.6L, 560 HP.
  • 88 hours
  • 2512 km.
  • Eaton Fuller 18 speed transmission.
  • 54’ free-standing mast, 65’ 11” crown to ground. 65,000 lbs static hook load vertical and 50,000 lbs static hook load slant work.
  • Gardner Denver, TEEF 4X5, Triplex Pump c/w Coors #10 steel valves, 6” suction manifold.
  • High pressure piping threaded c/w Oteco relief valve (Neutron Valves)
  • 450HP 1:1 ratio two shaft split box c/w air shift
  • 4:1 ratio chain case assembly c/w splined input shaft
  • Drive-lines fabricated & balanced to accommodate split box and chain case
  • Esso Gear 75W90-GX Extra oil for split box, chain case & triplex
  • Bowie three inch (3”) nitrile geared pump & hydraulic drive package, grease manifold, drip tray mounted on passenger side.
  • Bowie controls at rear control panel
  • Chelsea eight bolt Power-take-off c/w air shift
  • Hydraulic wet kit c/w pumps, filter, piping, hoses, fittings and oil
  • Power tong/BOP circuits
  • Two (2) SJ100 hydraulic rear leveling jacks c/w controls & jack stands
  • Split nuts for SJ100
  • Operators control panel c/w standard controls/gauges
  • HL-25-7-86-3-559 Pullmaster hydraulic winch c/w two speed rapid reverse and 3/4” groove drum (large drum) 3/4” cable for HL25 winch – 350 feet
  • Pullmaster PL5 auxiliary winch
  • 3/8” cable, chain and hook for auxiliary winch
  • Fifty-three (53ft) Flushby mast rated at 65,000# hook load vertical and 50,000# slant
  • Slant tray in mast (Square)
  • Two (2) hydraulic mast raising cylinders
  • Slant arm package c/w controls
  • Two sheave crown assembly for 3/4” wire rope
  • Custom fabricated A-Leg assembly
  • Engineer’s Certification and Inspection (Alberta-Saskatchewan)
  • 65,000 # single sheave traveling block (Heavy Duty)
  • Custom fabricated headache rack assembly
  • Over cab cable protector
  • Cable anchor bar for slip program
  • Rear bumper boxed c/w tow hook
  • One (1) cabinet tool box c/w doors at each end, light and heater mounted behind cab across frame
  • Two (2) aluminum tool boxes, mounted RH and LH rear (drawers in LH box)
  • One (1) varsol tank large with dry compartment –near Bowie as room permits
  • Pail holders as room allows
  • Standard light package c/w back-up alarm
  • Rod BOP c/w hand pump and 25Ft. fire-guard BOP hose (BOP mount)
  • Working floor adjustable for multiple working heights and ladder
  • Fall arrestor safety device c/w certified mounting block.
  • One (1) 25 ton Trico rod hook
  • Two (2) 25 ton Trico rod elevators c/w (4) -1” and plates and screws
  • One (1) 25 ton 1 ¼” plate type elevator c/w (2) 1 ¼” plates and screws
  • Ø Two (2) ¾” x 7/8” rod wrenches
  • Two (2) 1” rod wrenches
  • Trico rod spinner
  • Ground reel and cable
  • Fire extinguisher (2) 30 # ABC Type
  • Emergency warning system
  • Hydraulic weight indicator
  • Advance Aluminum Tank – 1.5m3 hydraulic/ 9m3 product Code TC406 Crude
  • Mounting plate and rest for hydraulic picker
  • 3” suction hose
  • 1 1/2” 5000# pressure hose
  • Electronic Titan tank level gauge (installed)
  • Electronic pressure gauge
  • Electronic counter totalizer